Kia Rio: ISG (Idle Stop & Go) System / ISG OFF switch

Kia Rio 2017-2024 YB Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / ISG OFF switch

Components and components location
Components

Description and operation
Description

The ISG OFF switch on the floor console can be used to deactivate the ISG function.

Schematic diagrams
Circuit Diagram

Repair procedures
Removal
1.

Disconnect the negative (-) battery terminal.

2.

Remove the front console upper cover.

(Refer to Body - "Floor Console Assembly")

3.

Disconnect the front console upper cover switch connector (A).

4.

Remove the front console upper cover switch (A) after loosening the mounting screws.

Installation
1.

Install the front console upper cover switch.

2.

Connect the front console upper cover switch connector.

3.

Install the front console upper cover.

4.

Connect the negative (-) battery terminal.

Inspection
1.

Remove the ISG switch.

(Refer to ISG System - "ISG Swtich")

2.

Using an ohmmeter, measure the resistance between switch terminals.

3.

If there is no continuity, replace the ISG OFF switch.

ISG Switch
Terminal
Measure
ON
1 - 8
continuity
OFF
1 - 8
No continuity

ISG (Idle Stop & Go) System
Components and components location Components Location 1 . Battery sensor 2 . Brake Booster Vacuum Pressure Sensor (BBVPS) 3 . AGM battery 4 . DC/DC converter ...

Fuel Delivery System
Components and components location Components Location Fuel Tank & Filler-Neck Assembly 1. Fuel Tank 2. Fuel Pump 3 Fuel Pump Plate Cover 4. Fue ...

Other information:

Kia Rio 2017-2024 YB Service Manual: Front Door Belt Inside Weatherstrip


Repair procedures Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Remove the front door belt inside weatherstrip (A). 3. Install in the reverse order of removal. ...

Kia Rio 2017-2024 YB Owners Manual: One time driving information mode (for type B cluster)


The vehicle will display Driving Information once per each ignition cycle. - Fuel efficiency is calculated after the vehicle has run for more than 300 meters (0.2 miles). - The Driving Information will be reset 4 hours after the ignition has been turned off. So, if the vehicle ignition is tu ...

Copyright © www.krioyb.com 2017-2024