Kia Rio: Front Seat / Front Seat Frame Assembly
Components and components location
1. Front seat back frame assembly
|
2. Front seat cushion frame assembly
|
Repair procedures
Put on gloves to protect your hands.
|
• |
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
• |
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the front seat back cover.
(Refer to Front Seat - "Front Seat Back Cover")
|
2. |
Remove the front seat cushion cover.
(Refer to Front Seat - "Front Seat Cushion Cover")
|
3. |
Remove the side airbag (SAB) module.
(Refer to Airbag Module - "Side Airbag (SAB) Module")
|
4. |
After loosening the mounting bolts, disconnect the front seat back frame
assembly (A) and front seat cushion frame assembly (B).
Tightening torque :
44.1 - 53.9 N·m (4.5 - 5.5 kgf·m, 32.5 - 39.8 lb·ft)
|
|
5. |
Install in the reverse order of removal.
•
|
Remove the side air bag for replacing side air bag installation
seat.
(Refer to Restraint - "Side Airbag (SAB) Module")
|
•
|
Before servicing, be fully aware of precautions and service
procedure relevant to airbag.
(Refer to Restraint - "Side Airbag (SAB) Module")
|
|
|
Components and components location
Component Location
1. Front seat cushion cover
Repair procedures
Replacement
...
Components and components location
Components
1. Front seat belt retractor
2. Height adjuster
3. Rear seat belt retractor [side]
4. Rear seat belt retract ...
Other information:
Stop and tail lamp (LED type) bulb replacement (for 4 door)
If the stop and tail lamp (LED) (1,2) does not operate, have the vehicle checked
by an authorized Kia dealer.
The LED lamps cannot be replaced as a single component because it is part of
an integrated unit. The LED lamps have to be ...
Components and components location
Components Location
1 . ECM (Engine control module)
2 . Manifold Absolute Pressure Sensor (MAPS)
3 . Intake Air Temperature Sensor (IATS)
4 . Engine Coolant Temperature Sensor (ECTS)
5 . Throttle Position Sensor (TPS) [ ...