Kia Rio: Front Seat / Front Seat Back Cover

Kia Rio 2017-2025 YB Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Back Cover

Components and components location
Component Location

1. Front seat back cover


Repair procedures
Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the front seat outer shield cover.

(Refer to Front Seat - "Front Seat Outer Shield Cover")

2.

Remove the front seat inner shield cover.

(Refer to Front Seat - "Front Seat Inner Shield Cover")

3.

Pull up the front seat headrest (A).

4.

Remove the front seat back cover lower protector (A).

5.

Remove the front seat back cover hog-ring.

6.

Zipper open the front seat back cover (A) and then pull it up.

7.

Disconnect the front seat back cover lower protector.

8.

Disconnect the airbag connector mounting clip (A) and heater connector (B).

9.

Turn the front seat back cover inside out. Then pull out and remove the headrest guides (A) while pinching both sides of the lower part of the guides.

10.

Remove the front seat back cover (A) from the front seat back frame.

11.

Remove the front seat back cover (C) from the front the seat back frame after removing the velcro tape (A) and hog-ring clips (B).

12.

Install in the reverse order of removal.

  

Make sure that the connectors are connected completely.

Replace any damaged clips (or pin - type retainers).

To prevent wrinkles, make sure that the cover (B) is stretched evenly before connecting the hog - ring clips (A).

Replace the hog-ring clips with new ones using special tool (C) (09880 - 4F000).

Front Seat Shield Inner Cover
Components and components location Component Location 1. Front seat shield inner cover Repair procedures Replacement ...

Front Seat Cushion Cover
Components and components location Component Location 1. Front seat cushion cover Repair procedures Replacement ...

Other information:

Kia Rio 2017-2025 YB Service Manual: SRS Control Module (SRSCM)


Description and operation Description The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not. The SRSCM must decide whether to deploy the restraint sys ...

Kia Rio 2017-2025 YB Owners Manual: Power outlet


The power outlet is designed to provide power for mobile telephones or other devices designed to operate with vehicle electrical systems. The devices should draw less than 12V, 15A with the engine running. Use the power outlet only when the engine is running and remove the accessory plug af ...

Copyright © www.krioyb.com 2017-2025