Kia Rio: If you have a flat tire (with Tire Mobility Kit) / Components of the Tire Mobility Kit

Kia Rio 2017-2025 YB Owners Manual / What to do in an emergency / If you have a flat tire (with Tire Mobility Kit) / Components of the Tire Mobility Kit

1. Speed restriction label
2. Sealant bottle and label with speed restriction
3. Filling hose from sealant bottle to wheel
4. Connectors and cable for the power outlet direct connection
5. Holder for the sealant bottle
6. Compressor
7. On/off switch
8. Pressure gauge for displaying the tire inflation pressure
9. Button for reducing tire inflation pressure

Connectors, cable and connection hose are stored in the compressor housing.

WARNING - Expired sealant

Do not use the Tire sealant after expiration date noted on the sealant bottle.This can increase the risk of tire failure.

WARNING - Sealant

Strictly follow the specified sequence, otherwise the sealant may escape under high pressure.

✽ NOTICE

Before using the tire repair kit, please read carefully the instruction attached on the sealant case. Detach the speed limit label on the sealant case and put it on a highly visible place. Always drive within the speed limit.

Notes on the safe use of the Tire Mobility Kit
Park your car at the side of the road so that you can work with the Tire Mobility Kit away from moving traffic. To be sure your vehicle will not move, even when you're on fairly level groun ...

Using the Tire Mobility Kit
Carefully follow below steps. 1. Shake the sealant case. 2. Connect the filling hose (3) onto the connector of the sealant bottle (A). 3. Insert the sealant bottle into the housing of the compr ...

Other information:

Kia Rio 2017-2025 YB Service Manual: Inhibitor Switch


Description and operation Description Detect the position of shift lever through the contact switch. Operation Table Schematic diagrams Circuit Diagram Repair procedures Inspection 1. Check the condition of connector. ...

Kia Rio 2017-2025 YB Service Manual: Fuel Filter (For Diesel engine only)


Repair procedures Replacement 1. Turn ignition switch OFF and disconnect the negative (-) battery terminal. 2. Remove the battery. (Refer to Engine Electrical System - "Battery") 3. Remove the ECM. (Refer to ...

Copyright © www.krioyb.com 2017-2025