Kia Rio: Operating door locks from inside the vehicle / With central door lock switch (if equipped)

■ Driver's door

■ Passenger’s door
Operate by pressing the central door lock switch.
- Press the switch to the “Lock” position (1), all vehicle doors will lock.
- Press the switch to the “Unlock” position (2), all vehicle doors will unlock.
- If the key is in the ignition switch (or if the smart key is in the vehicle)
and any front door is opened, the doors will not lock when the “Lock” position
(1) of the central door lock switch is pressed.
WARNING - Doors
- The doors should always be fully closed and locked while the vehicle
is in motion to prevent accidental opening of the doors.
- Be careful when opening doors and watch for vehicles, motorcycles, bicycles
or pedestrians approaching the vehicle in the path of the door. Opening a door
when something is approaching can cause damage or injury.
WARNING - Unattended children/animals/incapacitated persons
Never leave children, animals, or incapacitated persons unattended in your
vehicle. An enclosed vehicle can become extremely hot, causing death or severe injury
to unattended children, animals, or incapacitated persons who cannot escape the
vehicle.
With the door lock button
To unlock a door, pull the door lock button (1) to the “Unlock” position.
The red mark on the button will be visible.
To lock a door, push the door lock button ...
Impact sensing door unlock system (if equipped)
All doors will automatically unlock when an impact causes the air bags to deploy.
Auto door lock/unlock feature (if equipped)
• All doors will auto ...
Other information:
Ventilation
1. Set the mode to the position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed control to the desired speed.
Heating
1. Set the mode to the position.
2. Set the air intake control t ...
1. Open the trunk lid.
2. Remove the service cover by pulling out the service cover.
3. Remove the socket from the assembly by turning the socket counterclockwise
until the tabs on the socket align with the slots on the assembly.
4. Remove the bulb from the socket by pressing it in and rota ...