Kia Rio: Cruise Control system / To set cruise control speed

Kia Rio 2017-2025 YB Owners Manual / Driving your vehicle / Cruise Control system / To set cruise control speed

1. Press the CRUISE button on the steering wheel to turn the system on. The CRUISE indicator light in the instrument cluster will illuminate.

2. Accelerate to the desired speed, which must be more than 30 km/h (20 mph).

✽ NOTICE - Manual Transmission

For Manual Transmission vehicles, you should depress the brake pedal at least once to set the cruise control after starting the engine.

3. Move the lever down (to SET-), and release it at the desired speed. The SET indicator light in the instrument cluster will illuminate. Release the accelerator pedal at the same time. The desired speed will automatically be maintained.

On a steep grade, the vehicle may slow down or speed up slightly while going uphill or downhill.

Cruise control switch

CRUISE : Turns cruise control system on or off. CANCEL: Cancels cruise control operation. RES+: Resumes or increases cruise control speed. SET-: Sets or decreases cruise control speed. ...

To increase and decrease cruise control set speed

To increase cruise control set speed: Follow either of these procedures: Move the lever up (to RES+) and hold it.Your vehicle will accelerate. Release the lever at the speed you want. Move ...

Other information:

Kia Rio 2017-2025 YB Service Manual: Variable Force Solenoid (VFS)

Description and operation Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load.By controlling CVVT, the valve over ...

Kia Rio 2017-2025 YB Owners Manual: Tail lamp (Bulb type) bulb replacement (for 4 door)

1. Open the trunk lid. 2. Loosen the retaining screw of the trunk lid cover and then remove the cover. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 4. Remove the bulb from the socket by press ...