Kia Rio: Audio / Speakers
Repair procedures
Troubleshooting of the speakers |
When handling the speakers :
• |
Do not cause shock to the speakers by dropping or throwing them.
|
• |
Be careful not to drop water and oil on the speakers.
|
• |
Use caution to handle the speaker because diaphragm made of paper
is easily torn by impact or external force.
|
• |
Audio system tuning may cause damage to the speakers. The modified
speakers are not covered by the manufacturer’s warranty.
|
|
1. |
Basic inspection
Loosen the screws to rule out the interference from the body trims and
surrounding parts and then remove the speaker.
After removing the speaker, check the sound quality of the speaker with
the connector plugged in.
|
2. |
Inspection for each cause
(1) |
Abnormal vibration
–
|
Make sure the mounting screws are properly tightened
before replacing the speaker.
|
–
|
Reinstall the speaker and check that the symptom is resolved.
|
–
|
If the symptom does not disappear, replace the speaker
with a new one.
|
|
(2) |
Noise
–
|
Check that the speaker connector is properly connected
and reinstall the connector if necessary.
|
–
|
If noises occur in the radio mode, turn to the CD player
mode.
|
–
|
If noises occur in both modes, replace the speaker with
a new one.
|
If noises occur only in the radio mode, the poor radio
reception is the cause so do not replace the speaker.
|
|
(3) |
Poor working
–
|
Check the plus (+) and negative (-) speaker terminals
using an ohmmeter.
|
–
|
If resistance is measured at the specified value shown
below, the speaker operation is normal.
|
–
|
If the measured resistance is different from the specified
value, replace the speaker.
|
|
|
Front Door Speaker
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
3. |
Remove the front door speaker (B) after disconnecting the connector (A)
and loosening the bolts.
|
Tweeter Speaker
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Using a screwdriver or remover, remove the front door quadrant inner
cover (A).
|
3. |
Disconnect the tweeter speaker connector (A).
|
4. |
Remove the tweeter speaker (A) after loosening the mounting screws.
|
Rear Door Speaker
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
3. |
Remove the rear door speaker (B) after disconnecting the connector (A)
and loosening the bolts.
|
Front Door Speaker
1. |
Install the front door speaker.
|
2. |
Install the front door trim.
|
3. |
Connect the negative (-) battery terminal.
|
Tweeter Speaker
1. |
Install the tweeter speaker.
|
2. |
Install the front door quadrant inner cover.
|
3. |
Connect the negative (-) battery terminal.
|
Rear Door Speaker
1. |
Install the rear door speaker.
|
2. |
Install the rear door trim.
|
3. |
Connect the negative (-) battery terminal.
|
• |
Make sure that the speaker connectors are plugged in properly.
|
• |
Check the audio system for normal operation.
|
|
Components and components location
Components
[Radio/MP3 (A Type)]
Connector Pin Information
No.
Connector A
Connector B
...
Components and components location
Components
[Roof Antenna (Radio)]
[Roof Antenna (Radio + DAB)]
Repair procedures
Removal
Roof antenna
...
Other information:
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON position.
- It illuminates for approximately 3 seconds and then goes off.
When one or more of your tires are significantly underinflated.
❈For more details, refer to “Tire Pressure ...
Components and components location
Component Location
1. Cluster fascia panel
Repair procedures
Replacement
Put on gloves to protect your hands.
...