Kia Rio: Body Electrical System / Horn
Components and components location
| Component Location |
| 1. Horn switch 2. Horn relay |
3. Horn 4. Clock spring |
Repair procedures
| Removal |
| 1. |
Remove the front bumper assembly. (Refer to Body - "Front Bumper Assembly") |
| 2. |
Remove the horn (A) after disconnecting the horn connector (B) and loosening the mounting the bolt.
|
| Installation |
| 1. |
Install the horn after connecting the horn connector. |
| 2. |
Install the front bumper assembly. |
| Inspection |
| 1. |
The relay on the horn of this vehicle is built into the engine room relay block. |
Headlamp Leveling Switch
Components and components location
Components
Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remov ...
Ignition Switch
Repair procedures
Inspection
1.
Disconnect the key warning switch connector (A) and ignition switch connector
(B) from the steering column.
...
Other information:
Kia Rio 2017-2025 YB Owners Manual: Headlamp (Low/High beam) (LED type) bulb replacement (Headlamp Type B), Front turn signal lamp bulb replacement (Headlamp Type B)
Headlamp (Low/High beam) (LED type) bulb replacement (Headlamp Type B) If the headlamp (Low/High beam) (1) does not operate, have the vehicle checked by an authorized Kia dealer. Front turn signal lamp bulb replacement (Headlamp Type B) 1. Open the hood. 2. Remove the headlamp bulb cover b ...
Kia Rio 2017-2025 YB Service Manual: Front Stabilizer Bar
Repair procedures Removal 1. Remove the universal joint bolt (A). Tightening torque : 32.4 - 37.3 N·m (3.3 - 3.8 kgf·m, 23.9 - 27.5 lb·ft) ...
Copyright © www.krioyb.com 2017-2025
