Kia Rio: Windshield Wiper/Washer / Front Washer Motor
Repair procedures
| Inspection |
Front Washer Motor
| 1. |
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
|
| 2. |
Connect positive (+) battery cables to terminal 1 and negative (-) battery cables to terminal 2 respectively. |
| 3. |
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles. |
| 4. |
If they are abnormal, replace the washer motor. [Front & Rear washer]
|
| Removal |
Front Washer Motor
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the engine room under cover. D 1.4 U2 TCI (Refer to Engine Mechanical System - "Engine Room Under Cover") G 1.0 T-GDI KAPPA (Refer to Engine Mechanical System - "Engine Room Under Cover") G 1.2 MPI KAPPA (Refer to Engine Mechanical System - "Engine Room Under Cover") G 1.4 MPI KAPPA (Refer to Engine Mechanical System - "Engine Room Under Cover") |
| 3. |
Remove the front wheel guard [RH]. (Refer to Body - "Front Wheel Guard") |
| 4. |
Drain the washer fluid to less than 650 cc. |
| 5. |
Disconnect the washer hose (A) and washer motor connector (B). |
| 6. |
Remove the front washer motor (C).
|
Reservoir Tank
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the engine room under cover. D 1.4 U2 TCI (Refer to Engine Mechanical System - "Engine Room Under Cover") G 1.0 T-GDI KAPPA (Refer to Engine Mechanical System - "Engine Room Under Cover") G 1.2 MPI KAPPA (Refer to Engine Mechanical System - "Engine Room Under Cover") G 1.4 MPI KAPPA (Refer to Engine Mechanical System - "Engine Room Under Cover") |
| 3. |
Remove the front wheel guard [RH]. (Refer to Body - "Front Wheel Guard") |
| 4. |
Drain the washer fluid to less than 650 cc. |
| 5. |
Remove the wiring mounting clip (A). |
| 6. |
Disconnect the washer hoses (B) and connector (C). |
| 7. |
Remove the reservoir tank (D) after loosening the bolts.
|
| Installation |
Front Washer Motor
| 1. |
If necessary, clean the washer motor filter.
|
| 2. |
Install the front washer motor. |
| 3. |
Connect the front washer motor connector. |
| 4. |
Install the front wheel guard [RH]. |
| 5. |
Install the engine room under cover. |
| 6. |
Connect the negative (-) battery terminal. |
Reservoir Tank
| 1. |
If necessary, clean the washer motor filter.
|
| 2. |
Install the reservoir tank. |
| 3. |
Install the washer motor hose and connectors. |
| 4. |
Install the front wheel guard [RH]. |
| 5. |
Install the engine room under cover. |
| 6. |
Connect the negative (-) battery terminal. |
Front Wiper Motor
Components and components location
Component Location
1. Cap
2. Nut
3. Wiper arm & blade
4. Cowl top cover
5. Bolt
6. Wiper motor & linkage a ...
Rain Sensor
Components and components location
Components
Schematic diagrams
Circuit Diagram
Description and operation
Description
Integrated Rain Sensor
...
Other information:
Kia Rio 2017-2024 YB Owners Manual: Fan speed control, To turn off the blowers, Air conditioning
Fan speed control The ignition switch must be in the ON position for fan operation. The fan speed control knob allows you to control the fan speed of the air flowing from the ventilation system. To change the fan speed, turn the knob to the right for higher speed or left for lower speed. To ...
Kia Rio 2017-2024 YB Owners Manual: Sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console. The sunroof can only be opened, closed, or tilted when the ignition switch is in the ON position. CAUTION To prevent damage to the sunroof, periodic ...
