Kia Rio: System operation / Air conditioning
Kia Air Conditioning Systems are filled with R-1234yf refrigerant.
1. Start the engine. Push the air conditioning button.
2. Set the mode to the position.
3. Set the air intake control to the recirculated air position. However, prolonged
operation in the recirculated air position will excessively dry the air. In this
case, change the air position.
4. Adjust the fan speed control and temperature control to maintain maximum comfort.
- The refrigerant system should only be serviced by trained and certified
technicians to ensure proper and safe operation.
- The refrigerant system should be serviced in a well-ventilated place.
- The air conditioning evaporator (cooling coil) shall never be repaired or
replaced with one removed from a used or salvaged vehicle and new replacement
MAC evaporators should be certified (and labeled) as meeting SAE Standard J2842.
CAUTION - Excessive A/C
While using the air conditioning system, monitor the temperature gauge closely
while driving up hills or in heavy traffic when outside temperatures are high. Air
conditioning system operation may cause engine overheating and potential engine
damage. Continue to use the blower fan but turn the air conditioning system off
if the temperature gauge indicates engine overheating.
✽ NOTICE
When opening the windows in humid weather, air conditioning may create water
droplets inside the vehicle. Since excessive water droplets may cause damage to
electrical equipment, air conditioning should only be used with the windows closed.
Air conditioning system operation tips
- If the vehicle has been parked in direct sunlight during hot weather, open
the windows for a short time to let the hot air inside the vehicle escape.
- To help reduce moisture inside of the windows on rainy or humid days, decrease
the humidity inside the vehicle by operating the air conditioning system.
- During air conditioning system operation, you may occasionally notice a
slight change in engine speed as the air conditioning compressor cycles. This
is a normal system operation characteristic.
- Use the air conditioning system every month for a few minutes to ensure
maximum system performance.
- When using the air conditioning system, you may notice clear water dripping
(or even puddling) on the ground under the passenger side of the vehicle. This
is a normal operating characteristic of the system.
- Operating the air conditioning system in the recirculated air position provides
maximum cooling, however, continual operation in this mode may cause the air
inside the vehicle to become stale.
- During cooling operation, you may occasionally notice a misty air flow because
of rapid cooling and humid air intake. This is a normal operating characteristic
of the system.
Ventilation
1. Set the mode to the position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed contro ...
The climate control air filter installed behind the glove box filters the dust
or other pollutants that come into the vehicle from the outside through the heating
and air conditioning system. If ...
Other information:
The TPMS malfunction indicator will illuminate after it blinks for approximately
one minute when there is a problem with the Tire Pressure Monitoring System. If
the system is able to correctly detect an underinflation warning at the same time
as system failure then it will illuminate the TPM ...
Components and components location
Component Location
1. Rear seat belt buckle [RH]
2. Rear seat belt buckle [LH]
Repair procedures
Replacement
When installing t ...